Kuppersbusch USA EGS 304.2 - Manual (Page 3)

Installation instructions EEB 6800.0 / EEB 6600.0 / EEB 6500.0 3
General
=
Turn off the power source before installing the oven.
= WARNING! In case the oven is not installed and secured in accordance
with this installation instructions, there is a risk of tipover! Check after
installation that the fastening screws are securely seated and that the ap-
pliance cannot be moved.
= Only KÜPPERSBUSCH built-in cooktops have been designed and tested
for installation above a KÜPPERBUSCH built-in oven. No other cooktops
may be used above the oven.
= Only qualified personnel should perform installations and repairs on elec-
trical appliances. Do not repair or replace any part of the appliance unless
specifically recommended in this manual. Do not put your safety at risk.
Installation requirements
The oven must be placed on a board that can support a minimum of 62.5 kg/
140 lb. The oven is placed in direct contact with the side walls of the opening
with the frame overlapping these side walls.
WARNING! The furniture or adjacent side walls must be secured so the installed
oven can’t tilt.
Make sure there’s an opening in the back so there is enough air available for
cooling the oven. If there isn't an opening, cut a hole with at least 300 cm
2
/
45 in
2
depth in one of the adjacent surfaces, preferably in the bottom board
or top cover.
All components surrounding the oven should have a temperature resistance of up
to 100 °C/210 °F. This includes varnishes, edge bands, plastic surfaces, adhe-
sives and paints. The adjacent furniture fronts should be temperature-resistant up
to at least 70 °C/160 °F.
To eliminate the risk of burns or fire by reaching over heated surface units,
cabinet storage space located above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 5 inches beyond the bottom of
the cabinets.
Installation in a high cabinet
The frame of the oven overlaps the side walls on the right and left.
Installation under a countertop
The frame of the oven overlaps the boundary of the opening on all sides.