Kawasaki 840107 - Manual (Page 7)

CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger
on the Cordless Drill
is in the “OFF” position
and remove the battery
pack from the Cordless
Drill.
2. Plug 120V AC Adapter
into household outlet
and into side of battery
charger. Insert battery
pack into battery charger.
When the battery is
placed in the charger, the
red LED indicator light will remain on.
3. When fully charged, reattach battery pack onto Cordless Drill,
making certain latches fasten securely. Cordless Drill will not
operate properly if the battery pack is not seated properly.
ASSEMBLY
Be aware that this tool is always in an operating condition
because it does not have to be plugged into an electrical outlet. Always turn
the switch “OFF” and remove the battery pack before changing bits.
INSTALLING DRIVE BIT INTO KEYLESS CHUCK
Before inserting a drill bit or other accessory, make sure the forward/reverse
and trigger lock lever is in the center “OFF” position to prevent accidental starts
that may result in injury.
Do not attempt to tighten drill bits (or any other accessory) by gripping the
front of the chuck and turning the tool on. This may cause personal injury
and/or damage to the chuck.
When removing the bit from the tool, avoid contact with skin and use proper
protective gloves when grasping the bit or accessory. Accessories may be hot
after prolonged use.
WARNING
1. Hold the rear end of the chuck
in one hand and use the other
hand to rotate the front end in
a counterclockwise direction to
open the jaws of the chuck.
2. Insert the shank of the bit (or
other accessory) fully into the
keyless chuck, taking care to
keep the bit in the center of
the jaws of the chuck.
3. Turn the front end of the chuck clockwise to hold the bit in place.
4. Tighten securely by turning the front end of the chuck clockwise while holding
the rear end.
OPERATING THE DRILL
Never tape the trigger switch down to provide continu-
ous high speed. The tool may fail under such conditions causing fire or
personal injury.
VARIABLE SPEED TRIGGER SWITCH
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
• The speed of the Cordless Drill depends
on the amount of pressure you put on the
trigger.
• The more pressure you apply, the faster
the Cordless Drill will go.
• Release the pressure and the Cordless Drill
will slow down.
12 11
TRIGGER
SWITCH
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER
TIGHTEN
LOOSEN
HOLD