KORG TRITON Musical Instrument - Manual (Page 43)

TRITON Training Guide
41
2. Press the MENU key, then press P8 Edit - Insert Effect, and press the Routing tab. You'll see five
stereo Insert effects, chained, at the upper - right of the display. There are eight columns of timbres 1-8
in the lower field, each with specific routing and send parameters:
Timbre 1 Drums: IFX1 (chained from IFX1 through IFX5, so this timbre uses all the
insert effects.
Timbre 2 Drums: IFX5 (only bussed to IFX5's Stereo Compressor).
Timbre 3 Drums: IFX1 (same bus as timbre 1).
Timbre 4 Drums: Dkit (setting the bus to Dkit "points" this timbre's Program to the
individual drum sound's insert effect busses - set in GLOBAL P5 Drum
Kit - each drum sound can use / or not use a determined insert effect
or be bussed to individual outputs! Plus, with this bus setting, you can
set Send 1 and 2 levels to the Master effects!).
Timbre 5 SE: IFX3 ( No Stereo Graphic EQ (IFX1) or Stereo Compressor (IFX2) for
this timbre - it's bus starts at IFX3 Stereo Phaser, and is chained
through IFX4 and IFX5).
Timbre 6 SE: L / R (no insert effects for this timbre - just Send 1 and 2 level settings
to the Master effects!)
Timbre 7 / 8 SE: IFX3 (both timbres bussed to IFX3 - same as timbre 5).
TRITON makes it easy to route Combination timbres (and Sequencer tracks!)
Copying Insert effects in Combination mode:
Copying Insert effects in Combination mode is the same procedure as in Program mode. See the previous
section "Copy an Insert effect from another Program" to see how this is done.
Note:
When selecting effects for Inserts or Masters, effects 000 - 089 can be used. Effects 090 - 102
are double - size effects, and use twice the processing area of other effects. Master effects cannot
use double - size effects.
Tip:
For more information on Insert and Master Effects functions and features, see the TRITON Owners
manuals!