Karcher K 2.900M - Manual (Page 5)

English
5
„ Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
„ The connection between the power ca-
ble and extension cable must not lie in
water.
„ All current-conducting parts in the work-
ing area must be protected against jet
water.
„ The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
„ The appliance may only be connected
to alternating current. The voltage must
correspond with the type plate on the
appliance.
„ The minimum fuse rating required at the
socket outlet is 13 A (slow-blow).
„ To avoid accidents due to electrical
faults we recommend the use of sockets
with a line-side current-limiting circuit
breaker (max. 30 mA nominal tripping
current).
„ The plug and coupling of the extension
cable used must be watertight.
„ Always fully unroll electrical cables from
the cable drum.
„ This appliance was designed to be used
with detergents which are supplied or
recommended by the manufacturer.
The use of other detergents or chemi-
cals may compromise the safety of the
appliance.
Safety devices serve to protect the user
and must not be rendered inoperational or
their functions bypassed.
The switch prevents unintented starting of
the appliance. Stop the appliance during
breaks or after operation.
The safety catch on the trigger gun pre-
vents the appliance from being switched on
unintentionally.
The high pressure hose is specially con-
structed with reinforced walls to handle wa-
ter pressure up to 11 MPa (1600 psi) - it is
easily damaged and should be stored care-
fully.
„
Do not kink.
„ Do not drive vehicles over the hose.
„ Do not expose the hose to sharp edges
or corners.
Misuse will lead to ballooning or premature
failure and will invalidate warranty.
Safety Devices
Power switch
Safety catch
High pressure hose