Kustom V5 - Manual (Page 7)

1 3
1. AC POWER CORD RECEPTACLE:
Insert the AC cord (provided) firmly into the AC connector. NOTE: Replace the AC power cord if
protective jacket is damaged or ground pin is damaged or removed. The fuse is located in a housing just below the receptacle. Replace
only with same type and size. To remove the fuse, remove AC power cord and pull out on the tab above the fuse symbol located on the
fuse carriage. Place the new fuse in the carriage clip and re-insert.
NOTE: To prevent an electrical hazard, DO NOT replace fuse without using the fuse carriage. Replace the fuse carriage if lost
or damaged before re-inserting the AC power cord.
2. FUSE:
The fuse is located in a fuse tray just below the receptacle. Replace only with the same type and size. For your convenience,
a spare fuse is located inside the fuse tray toward the front. To replace fuse, remove AC power cord.
Remove fuse tray by pulling the tab located above the fuse symbol away from the receptacle.
3: SPEAKER OUTPUTS:
These 1/4” jacks are provided to connect the internal and/or external speakers to the V5.
THE AMPLIFIER SHOULD NEVER BE OPERATED WITHOUT A SPEAKER PLUGGED INTO A SPEAKER JACK.
ONLY ONE SPEAKER JACK CAN BE USED AT A TIME.
V5 Back Panel
2