Kohler Waterlite showerhead 8023A - Manual (Page 4)

4 1063864-AN2-E 17/02/12
Install the Watertile Showerhead
Prepare the Housing:
1. Position the housing so that the back of
the leak shield is facing you.
2. Apply a bead of silicone sealant in
the groove around the outside of the
housing. Do not apply silicone sealant
in or near the weep hole.
3. Allow the silicone sealant to cure.
Install the Components:
1. Position the housing with the sealant
side towards the finished wall and
the narrow end of the housing facing
down.
2. Position the so that the nipple is through
the centre and press firmly against the
finished wall.
3. Thread the adaptor onto the nipple.
Install the Waterway:
1. Press the waterway into place over the
adaptor.
2. Secure the waterway to the adaptor
with the screw provided. The waterway
will be secure once the housing is
completely seated against the wall and
does not turn or move.
Finished Wall
Housing
Waterway
Adaptor
Double Ribs
Slot
Apply Silicone Sealant
Weep Hole
Leak Shield