Kenwood TK-2160 - Manual (Page 5)

TK-2160
5
DISASSEMBLY FOR REPAIR
/ /
Ω
≈
,
Packing
1. Separating the case assembly from the chassis.
1. Remove the volume knob z .
2. Remove the two screws x .
3. Lift the chassis c , and remove it from the case assembly.
Note: After separating the case assembly from the chassis,
remove the channel knob.
2. Separating the chassis from the TX/RX unit.
1. Remove the two screws v fixing the TX/RX unit B/2.
2. Remove the twelve screws b and two screws n fixing
the TX/RX unit A/2.
3. Remove the solder from the antenna terminal using a
soldering iron m , then lift the unit off.
z
x
x
c
Channel knob
≈
m
,
.
v
v
b
b
b
b
b
b
b
n
TX/RX UNIT B/2
TX/RX UNIT A/2
3. How to remove the battery terminal block.
1. Remove the two screws / , then pull out the back cover Ω .
2. Remove the screw ≈ .
Note: To remove the TX/RX unit B/2, remove the solder using
a soldering iron . .
Note: The two screws n of TX/RX unit A/2 are fixing the
battery terminal block , .