Kenwood KDC-C667 - Manual (Page 3)

■ Accessories
A × 1 B × 4 C × 4 D × 1 E × 1
■ Removing the transportation screws
Remove all 3 transportation screws for protecting the
internal mechanism before you start to install the unit.
After removing the transport screw, retain it carefully and
attach it again before transporting the unit again.
NOTE
Transportation screws
■ Angle adjustment switches
• The angle adjustment switches on the both
side of the unit are to be set according to the
angle of installation of the CD auto changer.
Set both of the two switches to the same
position. If the switches are not set properly,
sound skip or other malfunction may occur.
• Set the angle adjustment switches with a
coin or other flat object.
• Change the switch step by step by detaching
and reusing the object at the end of each
step.
90
0 45
90
0 45
Right side
Left side
Angle adjustment
switches
It is not possible to
install at an angle of
40°~50° if only A is
used.
90
0
45
90
0
45
90
0
45
Installation angle
Angle adjustment
switch position
85°~90° 40°~50° 0°~5°
'
Loading compact discs
'
'
O - N
'
'
'
Make sure the disc magazine is the right
way up with the "disc" logo on the top.Pull
the tray out by the projection.
Projection
"EJECT"
1
2
3
4
5
6
Tray
Place the disc on the tray with the label fac-
ing upwards. Insert the tray into the disc
magazine until it locks. Check that the discs
and trays are inserted properly. The discs
are numbered from the bottom from 1 to 6
or 10.
• Take care to insert trays into the correct
grooves in the disc magazine and to insert
discs properly into the tray grooves.
Otherwise malfunction may occur or the
disc may be damaged.
• Insert all trays even when some of them
do not carry discs. Otherwire malfunction
or operation failure may occur.
• 8-cm discs cannot be used. If an 8-cm
disc adapter is used, the disc cannot be
ejected.
2CAUTION
Open the CD changer door.
Insert the magazine into the CD changer
until it clicks.
Close the CD changer door.
Use the CD changer with its door closed to
prevent the entry of dust into the changer.
NOTE
Open the CD changer door, and press the
"EJECT" button.
Be sure to open the door completely before
pressing the EJECT button. If the door is
not completely open, the magazine may hit
the door and cause damage of malfunction.
NOTE
Magazine ejection
Installation