Kohler K-16111 - Manual (Page 4)

2. Install the Valve Body
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheons according to the manufacturer’s instructions.
Thread the hoses to the valve body outlets and wrench tighten.
Do not overtighten.
Insert the valve bodies into the mounting holes from the top of
the sink. Make sure the hot valve body is installed in the
left-hand hole and the cold valve body is installed in the
right-hand hole.
Install a washer and then a nut to the bottom of the valve bodies.
Align the valve bodies so the copper tubing faces the outside.
Wrench tighten the nuts.
Remove any excess plumbers putty.
Connect and wrench tighten the hoses to the shank tee. Do not
overtighten.
Escutcheon
Hose
Nut
Shank
Tee
Washer
Apply
plumbers
putty.
Valve Body
1004636-2-D 4 Kohler Co.