Kambrook KFH500 - Manual (Page 8)

8
Using Your Low Profile Fan Heater
Setting the Heating Mode
To control the heater, turn the Heat
Setting dial as follows.
The Heat Setting dial has 4 modes:
OFF - Shuts off the heater and fan
FAN
- For fan only operation
1 - Low heat setting (1200 watts)
2 - High heat setting (2400 watts)
Turn the heater off by turning the Heat
Setting dial to the OFF position.
NOTE: This heater features a tip-
over switch. If the heater tips
over, it will automatically switch
off. Once placed back into the
upright position, the heater will
automatically switch on again.
Before First Use
Remove any promotional material
and packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable, upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
Turning Your Heater On
Ensure the Heat Setting dial is turned
to the OFF position and Variable
Thermostat dial to “MAX”.
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
The Power-On Indicator, on the front
of the heater, will illuminate when the
heater is turned on.
KFH500_IB_FA.indd 8 12/10/09 9:49 AM