Kyocera Phantom TXLCC10042B - Manual (Page 43)

User Guide for Kyocera Phantom Phones 35
Data settings
Setting Com port speed
The Com Speed sets the data rate at which your
phone connects to a laptop or PC, or at which it
sends and receives over-the-air text messages.
1. Select Menu
→
Settings
→
Accessories
→
Com Speed .
2. Select the speed. The options are: 19.2 kbps ,
115.2 kbps (default), 230.4 kbps .
Note: There may be a higher charge for making
calls using high-speed data in areas where 1X
service is available. Check with your service
provider for details.
Setting the phone to receive data
or faxes
Your phone may be able to receive certain data or
faxes, depending on the system sending the
information. To receive data or faxes, you must
connect the phone to a laptop or PC and switch the
phone from voice mode to data/fax mode.
Note: To purchase a cable, contact your service
provider, call (800) 349-4188 (U.S.A. only) or
(858) 882-1410, or visit
www.kyocera-wireless.com/store .
1. Connect the phone to the laptop or PC.
2. Set the Com Speed.
3. Select Menu
→
Settings
→
Network
→
Data/Fax Calls .
4. Press to select an option:
– Voice only— Allow only voice calls.
– Fax next call or Data next call— Set the
phone to fax mode or data mode for the
next incoming call or the next 10 minutes.
– Fax until off or Data until off— Force the
phone into fax mode or data mode until the
phone is turned off.
Note: You cannot receive voice calls while the
phone is in data/fax mode.
Connecting to a TTY/TDD device
TTY/TDD may not be available on your phone.
Check with your service provider for availability.
You can connect the phone to a TTY device for the
hearing impaired.
Note: Enable TTY only when
using the phone with a TTY device.
1. Connect the TTY device to the phone.
2. Enter from
your keypad.
3. Press to select the TTY option.