Kenwood D-S300 - Manual (Page 17)

1 7
D-S300 (En)
To check or change the programmed tracks
÷
Press it while the “PGM 01” indicator blinks.
÷
The track being played cannot be changed.
÷
Perform only step 1 to simply check the program.
÷ In the case of a CD-TEXT disc, the track’s title is scrolled on the display.
÷
Each time the key is pressed, the program No. and the track No. on CD
are displayed.
G P 0 M 1 N T . O 5 2
Blinks.
Example
↓
Remote control unit only
Auto space function
During programming of tracks, a non-recorded space of a few
seconds will be automatically created between tracks. By re-
cording tracks with these spaces on tape, the search and repeat
play operations of tape using the DPSS function (which works
by searching the non-recorded spaces) can be performed reli-
ably. ÷
Even when the performances of two tracks are continuous (which
occurs with classical or live recording music), the spaces will be
created if they have different track Nos.
Press until the track No. to
be changed is displayed.
Check
ENTER
1
Press the CHECK key.
To add a track to the program
Remote control unit only
P.mode
ENTER
P.MODE
3
Set the entry.
2
Select the new track No.
1 2 3
4 5 6
7 8 9
0 +10
ENTER
+10
5 4 3 2 1
0 9 8 7 6
CHECK
To clear tracks from the program
Remote control unit only
CLEAR
Clear
ENTER
Press to clear tracks from the end.
1
Select the desired track No.
P.mode
ENTER
P.MODE
To clear all track.
2
Press the P.MODE key.
1 2 3
4 5 6
7 8 9
0 +10
ENTER
+10
5 4 3 2 1
0 9 8 7 6
GRC operation RC operation
GRC operation RC operation
GRC operation RC operation
÷
Each time the key is pressed, the last track in the program is cleared.
÷ The tracks which are programmed earlier than the track being played
cannot be cleared.
÷
Selected tracks can be also completely cleared just by operating the 0
key.
÷
The entire program is cleared.
÷
When a track No. is selected, the track will be added to the end of the
existing program.
Programmed play (PGM mode)