Kompernass KH 2400 - Manual (Page 10)

- 8 -
Steam ironing
Unwind the mains lead. Ensure that the
iron is disconnected from the power sup-
ply before you fill it with water. Turn
steam regulator
µ to the dry position (0
position) and the temperature control
knob
ᕣ to MIN.
Fill the iron with water. Ensure that the
MAX marking line is not exceeded. Con-
nect the appliance to the mains power
supply again. The blue shut-off indicator
light in water tank
ᕢ comes on.
Set the temperature control knob ᕣ to
the steam position and the heating
light Ƹ will illuminate. In this setting,
the iron can be used as a steam iron
once the heating light
Ƹ goes out. The
heating light Ƹ will illuminate and go
out regularly during ironing as an indi-
cation that the temperature control is
working properly.
Turn the steam control gear µ to the
steam position and the iron will create
steam. Turn the steam control gear to
the position 0, and the steam will cease.
Steam adjustable
Setting the knob
You can adjust the steam easily with the
7 positions of the steam control gear.
Put the iron on the heel rest when rear-
ranging clothing or while not in use.
Steaming stops when the iron is placed
on the heel rest.
Using the steam burst button
Be sure there is water in the tank ᕢ and
the temperature control knob ᕣ is on
steam.
Using the iron horizontally
Lift the iron and press the steam burst
button
¹. You may need to press this
button ¹ a few times after filling the
iron with water to activate the pump.
The burst steam facility can be used only
when ironing at temperature of at least
150° C, this means form III to MAX.
Using the iron vertically
KH2400
IB_KH2400_E6473_UK 27.06.2007 16:44 Uhr Seite 8