Using the security lock – Knoll Systems HD102 User Manual
Page 26
26
WARNING:
To avoid burns, allow the projector to cool for at least 30 minutes before you replace the lamp.
Do not drop the lamp housing or touch the glass bulb! The glass may shatter and cause injury.
Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small
glass fragments may be generated. The lamp housing is designed to contain these fragments, but use
caution when removing the lamp housing. Before replacing the lamp, clean the lamp compartment and
dispose of cleaning materials. Wash hands after lamp replacement. This product has a lamp, which contains
a very small amount of mercury. Dispose of it as required by local, state or federal ordinances and
regulations. Fo
6
Carefully remove the lamp housing.
Dispose of the lamp in an
environmentally proper manner.
7
Install the new lamp housing and
tighten the screws.
8
Re-attach the lamp connector to the
projector. The locking tab should
engage when the connector is fully
plugged in.
9
Replace the lamp door.
10
Plug in the power cord and toggle
the Power switch to turn the projector
back on.
11
To reset the lamp hour timer, navigate to the
Settings>Service menu and select Lamp Reset. See
page 24 for details.
Cleaning the Lamp Housing Screens
In dirty or dusty environments, the two dust filter screens in the lamp housing
can become clogged, causing high
temperatures and premature lamp
failure. Routine maintenance to
remove dust from the screens
lowers the lamp operating
temperature and prolongs lamp life.
To maximize lamp life, you should
clean the screen at least every 250
hours depending upon
environmental conditions. The
dirtier or dustier the environment,
the more often you should clean
the screens.
1
Remove the lamp housing.
2
Examine the dust filter screens on the lamp housing. If necessary, use a vacuum cleaner set on low power
to clean the screens. Be careful not to disturb any internal components when cleaning the screens.
3
Replace the lamp housing and lamp door.
Using the security lock
The projector has a security lock for use with a
PC Guardian Cable Lock System. Refer to the
information that came with the lock for instructions
on how to use it.