Keys Fitness KF-2-5T - Manual (Page 8)

8
Assembly
5. Connect the console harness together.
One side of harness is coming from the left
upright. The other end is coming from the
console.
Connect the amplifier harness together.
One side of harness is coming from the left
upright. The other end is coming from the
console.
Attach the console onto the uprights by
sliding into the uprights.
Secure the console to the uprights using
two bolts M10x25 and two washers #10
per side.
6. Locate the left and right covers.
Secure the covers to the console using
three screws on each side.
Figure 5: Securing Console Assembly to Uprights
Figure 6: Cover Installation
Bolt M10x25
Washer #10
Console
Console
Harness
Screw ST4.2x12
Right Cover
Console
Left Cover
NOTE: Make sure not to pinch or screw
through any wires when securing the left
handlebar.
NOTE: Make sure that the console har-
ness is inside of the upright and not being
pinched.
Amplifier
Harness
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2
through Step 5.