Kaidan TM-400 - Manual (Page 6)

Page - 6
Chapter 1
S
TEP
C: A
TTACHING THE SIDE SUPPORTS TO THE BASE
The side supports (Item #2) will accept the four industrial glides, two on each side. Attach them using the 1/
2” flat washers, lock washers and nuts(Fig A). Once you have attached the industrial glides, each side support
can be attached to either side of the base assembly. To attach the side supports use the 3/8 socket screws
(Item 6) including a 3/8 flat & lockwashers(Fig B).
Fig. A
Fig. B
S
TEP
D: A
TTACHING MOTOR AND TO THE BASE
The motor(9) ships with the 3/8” hub and coupler attached. The coupler has grooves that will mate with
the grooved hubs attached to the motor(9) and turntable gearbox(7). Remove and use the four 10-24 screws
in the base assembly, attach the motor and align the coupler with the hubs.(Fig C) Take the motor cable and
attache the appropriate end to the wire harness coming from the motor
Gearbox
Motor
Coupler
Fig. C