Kalorik USK EXP 4 - Manual (Page 6)

6 USK EXP 4 - 070830
• Place the small (11) or the large filter (12) correctly in the filter
holder.
• According to the required number of cups, fill the small or large
filter with 1 or 2 measures of special espresso coffee powder using
the measuring spoon (13).
• Then press the coffee with the tamper (13).
• Insert the filter holder (3) in the support of the filter holder (14).
Therefore, place the handle (6) of the filter holder to the left and
check that the filter locking lever (15) is as far as possible from the
filter by pulling it to you. Insert the filter holder in its support and
turn it firmly to the right until it blocks. The filter holder should be as
far to the right of the closing zone as possible and at least in the
middle of the appliance. This will avoid that the filter holder
comes out of its housing as the pressure rises when the coffee is
flowing. If the filter holder does not fit in the closing zone and at
least in the middle of the appliance, do not operate your
appliance, remove the filter holder and position it again as
described here above.
• Place one or two cup(s) on the grid of the drip tray (4) and under
the dripping holes of the filter holder.
• Check that the function selector (9) is in off position and place
the ON/OFF switch (5) in ON position. The red power light (2) of
the switch will illuminate and indicate that the appliance is
switched on.
• Wait until the blue ready light (8) lights up. When it comes on, turn
the function selector (9) to . The pump will start functioning
and a few seconds later the coffee will start coming out through
the openings of the filter holder. At the beginning you can hear
that the pump makes more noise than when the water starts
flowing. This is absolutely normal.
• When the cup(s) is (are) filled, turn the function selector (9) back
to “0" and the water will stop flowing.
• To prepare other espressos, empty the used coffee of the filter.
Therefore you have to remove the filter holder by turning it to the
left. CAUTION: Be careful when you remove the filter holder
because the metal parts may still be hot. Never remove the filter
holder when the function selector is not in “0” position. Put the
filter locking lever (15) against the edge of the filter in order to
block it and beat the filter holder above the bin. Rinse the