Kenwood H2EV - Manual (Page 13)

25
• Frequency
• FM On/Off
The Frequency submenu allows you to select an
unused FM channel frequency. Check your vehicle
radio to find a quiet channel, then use this submenu
to select the same frequency. The default is 88.1MHz.
The FM On/Off menu controls whether the
Here
2 Everywhere is transmitting on the FM channel
or not. Set this to “On” if you want to use the wire-
less FM feature. The default is “On”.
Add/Skip Channels Option
This allows you to select channels that you want to
skip when scanning up and down the Channel List
and Category List screens, or simply when you’re
using the Control Knob.
1. Use the Control Knob (or the remote CH buttons)
to highlight the channel you want to skip. (The
highlighted channel will automatically play.)
2. Press the Control Knob (or the remote Select
button) to change the highlighted channel’s status.
The word “skip” will appear after the channel name.
3. To remove the “skip” from the channel, press the
Control Knob (or the remote Select button) again.
4. To exit the Channel Skip function, press the
Menu button.
A channel marked as “skip” can still be tuned to by
using the remote’s Direct Tune feature. Also, if the
channel was programmed as a Preset, the Preset
will still tune the channel. To lock out a channel
completely, with security against changing, use the
Device Lock menu option.
Device Lock Options
This option allows you to lock channels more
securely than with the skip feature. The lock feature
will prevent a channel from being tuned to without
the security code.
This option brings up a submenu with two
additional options.
• Lock/Unlock
• Edit Code
Lock/Unlock
Upon entering this submenu for the first time, you
will be prompted to enter a 4-digit numerical code
that will be used to lock/unlock channel access.
24
SIRIUS ID Menu Option
When you select this option, the unit’s unique
12-digit SIRIUS ID Number will be displayed:
Display Settings
Press the Menu button to enter the Menu Options,
and select Display Settings with the Control Knob
(or the remote CH buttons). Press the Control Knob
(or the remote Select button) to enter the Display
Settings menu.
Dimming Control on the
Display Settings Menu
This setting controls the brightness of the display.
Adjust the setting with the Control Knob and press
the Control Knob to save the change. Press the
Menu button to cancel changes and return to the
previous menu.
Contrast Control
This setting controls the contrast of the display.
Adjust the setting with the Control Knob and press
the Control Knob to save the change. Press the
Menu button to cancel changes and return to the
previous menu.
Auto Dimmer
This is an on/off setting. When on, the auto dimmer
will raise or lower the display brightness based on
the brightness of the room or vehicle. When off, the
display does not adjust to room lighting.
For each of these controls, use the Control Knob
(or the remote CH buttons) to select the desired
setting, then press the Control Knob (or the remote
Select button) to accept the new value. Press the
Menu button to exit without making any changes.
Confirm Tone Option
This is an on/off option to select whether
Here
2
Everywhere beeps to confirm certain operations.
FM Transmitter Option
This option controls the wireless audio feature of
Here
2
Everywhere. This feature allows you to trans-
mit the Here
2
Everywhere audio directly to your vehicle
radio on a specific (unused) FM channel. This
option brings up a submenu with the following
additional options:
KEN.4061 ReceiverCarHome Manual 11/18/04 12:46 PM Page 24