Kambrook AQUARIUS CORDFREE KAK35 - Manual (Page 7)

7
Operating Instructions
Before First Use
Remove any packaging material and
promotional labels before using the
kettle for the first time.
It is recommended before the first
use to fill the kettle to the maximum
level with cold tap water, bring to the
boil and then discard the water. Your
kettle will only operate when the ON/
OFF switch in the ‘ON’ position. The
kettle will automatically switch off
once the water has boiled.
Operation Of Your Kettle
1. To fill the kettle with water, remove
the removable power cord and
open the lid by pressing the button
on the lid of the kettle and lifting
it upwards. Fill with the desired
amount of water. Do not operate
the kettle without water. Always fill
the kettle between the minimum
and the maximum marks on the
water window. Too little water will
result in the kettle switching off.
2. Ensure that the lid is closed and
locked firmly into place before
plugging in the removable
power cord.
3. Plug the kettle firmly onto the
removable power cord. Plug the
power cord into a 230V or 240V
power outlet and switch ‘ON’.
4. Press the ON/OFF switch to the
‘ON’ position. The power ‘ON’ light
will illuminate.
NOTE: Never operate the kettle
dry - too little water will result in the
kettle switching ‘OFF’.
Do not overfill the kettle - filling
above the maximum mark on the
water window may result in boiling
water splashing from the kettle.
NOTE: This kettle must only be
used with the removable power
cord supplied. Use caution
when pouring water from your
kettle, as boiling water will
scald. Do not pour the water
too quickly.
NOTE: Do not remove the kettle
from the removable power
cord during operation. Ensure
the kettle has switched to the
‘OFF’ position after the water
has boiled before removing the
removable power cord.
5. The kettle will automatically switch
‘OFF’ once the water has boiled.
Remove the removable power
cord from the kettle and pour the
water. Take care to hold the kettle
level, especially when filled to the
maximum level. To re-boil it may be
necessary to wait for a few seconds
to allow the control to reset.
The kettle should be stored away when
not in use. The power outlet should
be switched off and the removable
power cord unplugged from the
power outlet when not in use.
KAK35_IB_D11_FA.indd 7 17/08/11 4:49 PM