Kalorik USK JK 32207 - Manual (Page 5)

5 USK JK 32207 JK 32850 - 100225
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or
before any operation.
•
Open the lid by holding its release button and fill the tank with
fresh water, paying attention not to fill under the minimum mark
and above the maximum mark on the water level indicator.
•
Close the lid by pressing it down until it you hear a click. Make
sure it closes correctly.
•
Make sure the spout filter is well in position, as else the auto-shut
off feature would not work.
•
Put the jug onto the power base, plug into the wall socket and
switch on. The pilot light of the switch will come on, indicating that
the appliance is operating. If it does not come on, check if the
kettle is correctly positioned on the base and check if the base is
plugged in. The jug kettle will switch off automatically when the
water has boiled. However, you can stop the jug kettle anytime by
putting the switch in off position.
•
For instant re-boiling, wait until water has cooled down and
switch on the appliance again.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device if
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
•
In this case, switch off the appliance by putting the switch in OFF
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
•
The kettle may then be used as normal.