Kodak OL400-10 - Manual (Page 9)

Upgrading the KODAK OMS Imaging Software
KODAK Orthodontic Imaging Software Installation Guide (OR120) 7
8. Click Finish . A message is displayed, prompting you to restart your computer.
9. Click OK to restart your computer. After your computer restarts, a message is displayed,
prompting you to select the feature to install.
10. Click Exit and repeat these steps to install the software on each workstation in your
network.
Upgrading the KODAK OMS Imaging Software
To upgrade the Kodak OMS imaging software, follow these procedures:
• Upgrade the software on the image server.
• Register the software on the image server.
• Upgrade the software on each workstation.
• Connect and install any imaging hardware.
Upgrading the Software on the Image Server
To upgrade the Kodak OMS imaging software on an image server, follow these steps:
1. Exit any applications running on this computer and on each network computer containing
the imaging software.
2. Insert the software DVD in the DVD-ROM drive on the image server. The KODAK OMS
Imaging install menu is displayed.
Figure 6 KODAK OMS Imaging Install Menu Window
Important
The software must be
installed on each
network computer
containing practice
management
software.
Caution!
Before performing a
server installation on
a computer with the
Vista operating
system, contact
technical support for
assistance.
Note
If you are installing the
software using a cd,
insert the cd into the
CD-ROM drive.