Kambrook SLIMLINE SILENT KPH200 - Manual (Page 10)

10
1. Plug the cord into a 230-240V
electrical outlet. Be sure the
plug fits tightly, as a loose fit
will cause overheating and
damage the plug. To avoid an
electrical circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit with your heater
when you switch the unit on.
2. There are two ON/OFF switches
located at the top left hand side
of the rear of the heating unit, with
4 settings.
- OFF
- Low (800W)
- Medium (1200W)
- High (2000W)
When the heater is not in
operation, both switches will be in
the OFF position.
3. To activate the LOW heat setting,
press the switch marked 800W
from OFF to ON.
4. To activate the MEDIUM heat,
setting, press the switch marked
1200W from OFF to ON.
5. To activate the HIGH heat setting,
press both the 800W & 1200W
switches from OFF to ON.
6. To turn the heater completely
off, return both of the OFF/ON
switches to the OFF position.
ThermoGuard Overheating
Safety Device
Your heater is fitted with a safety
device that switches off the heater
in the event of overheating. Should
this heater stop working, turn off the
heater and inspect the air inlet and
outlet for blockages. Wait at least five
minutes for the protection system to
reset before attempting to restart
the heater.
If the heater fails to operate or the
safety device switches off again,
return the heater to your nearest
Kambrook Service Centre for
examination or repair.
Operating Instructions
KPH200_IB_Issue1,10.indd 10 4/12/09 2:01 PM