KORG BX-3 - Manual (Page 23)

Basic functions
23
4. In the upper DRA WBAR SELECT section, hold
down the [DRA WBAR 1] key and press the [DRA W-
BAR PRESET] key.
The Drawbar 1 settings will be copied to the “UPPER”
parameters, and an “ ” will appear between the
program number and program name.
5. Press the [WRITE/ENTER] key to write the settings
into internal memory .
For details, refer to “Writing a program” (p.20).
The upper DRAWBAR SELECT section can be used
to copy drawbar parameters in EX mode as well.
Create the sound in the upper keyboard, then hold
down the upper [DRAWBAR 1] or [DRAWBAR 2]
key, and press the [DRAWBAR PRESET] key.
Copying a program
This is convenient when you want to create several
variations of a program by making small changes to the
parameter settings.
1. Press the [GLOBAL] key to enter the Global mode.
2. Press the PROGRAM [7] key , and then press the
[ ® ] key once.
The display will indicate Copy Swap Init.
3. Press the [WRITE/ENTER] key .
In the display, “Copy” will blink, and the copy source
and copy destination program numbers will appear at
the right.
4. Press the [ ® ] key once, and the Speaker icon will
appear at the left of the copy-source program
number.
You can play the keyboard to hear the sound of the
program.
5. To change the copy-source, use the [-][+] keys to
specify the source program number .
6. To change the copy-destination, press the [ ® ] key
once, and then use the [-][+] keys to specify the
destination program number
.
The Speaker icon will appear at the left of the copy-
destination program number.
7. Press the [WRITE/ENTER] key .
A message will ask you to confirm the copy.
If you decide to cancel, press the [EXIT] key.
8. Press the [WRITE/ENTER] key once again.
When the program has been copied, the display will
indicate Copy Completed.
Swapping two programs
This operation exchanges two programs. This is conve-
nient when you want to rearrange the order of the
programs.
1. Press the [GLOBAL] key to enter the Global mode.
2. Press the PROGRAM [7] key , and then press the
[ ® ] key once.
The display will indicate Copy Swap Init.
3. Press the [WRITE/ENTER] key , and then press the
[+] key once.
“Swap” will blink in the display. The swap-source and
swap-destination program numbers will be displayed
at the right.
4. Press the [ ® ] key once, and the Speaker icon will
appear at the left of the swap-source program.
You can play the keyboard to hear the sound of the
program.
5. If you want to change the swap source, use the
[-][+] keys to specify the source program number .
6. If you want to change the swap destination, press
the [ ® ] key once, and then use the [-][+] keys to
specify the destination program number .
7. Press the [WRITE/ENTER] key .
A message will ask you to confirm the swap.
If you decide to cancel, press the [EXIT] key.
8. Press the [WRITE/ENTER] key once again.
When the swap is completed, the display will indicate
Swap Completed
.