Kambrook SNUGASABUG KFH280 - Manual (Page 3)

4
Heating
Turn the Heat Control Switch to the
desired power level (I or II).
Turn the thermostat knob clockwise
until the maximum temperature setting
is reached.
Thermostat
The thermostat is used to control the
room temperature. It acts as a switch and
does not vary the amount of heat output
from the heater.
Turn the thermostat knob clockwise
until the maximum temperature setting
is reached.
If the desired room temperature is
reached, slowly turn the thermostat
knob anti-clockwise until you hear a
click.The heater will stop operating.
The heater will now turn on and off
automatically maintaining the room
temperature that you have set.
Frost Watch
The frost watch setting is used to prevent
the room temperature from falling below
approximately 5ºC.
Choose the power level desired on the
heat control switch.
Turn the thermostat knob to the * symbol
(minimum setting).The heater will now
switch on automatically if the room
temperature falls below 5ºC.
Tilt Base
The direction of the airflow may be
adjusted by tilting the body of the heater
up and down. Stopper pins are fitted to
limit the angle of adjustment.
CLEANING INSTRUCTIONS
The heater requires regular cleaning to
ensure trouble free operation.
1. Unplug the heater from the mains
supply before cleaning.
2. Use a damp cloth to clean the exterior
of the heater.
3. Use a vacuum cleaner to remove dust
and fluff from the inlet and outlet grilles.
4. Ensure the heater is dry before plugging
back into the mains supply.
The use of an extension cord with this
appliance is not recommended.
Do not remove plug from power socket
until the appliance has been switched off.
Do not remove plug from power socket
by pulling flex – always grip plug.
Always unplug appliance when not in use.
Do not allow cord to come in contact
with heated surfaces during operation.
Do not run cord under carpeting, throw
rugs, runners or the like. Arrange cord
away from traffic areas so that it will not
be tripped over.
Do not twist, kink or wrap the cord
around the appliance, as this may cause
the insulation to weaken and split. Always
ensure that all cord has been removed
from the cord storage area.
Do not store appliance while it is still hot.
This appliance is not intended for use by
young children or infirm persons without
supervision.
Young children should be supervised to
ensure they do not play with the appliance.
The appliance must not be located
immediately below a socket-outlet.
Do not use this appliance in the
immediate surrounds of a bath, shower
or swimming pool.
If the supply cord is damaged, it must be
replaced by a qualified electrical person
in order to avoid a hazard.
Do not use this appliance outdoors, or
on wet surfaces. Avoid spilling liquid on
the appliance.
OPERATING
INSTRUCTIONS
Always choose a safe location for the
heater, keeping in mind the safety
precautions outlined. All of the controls
are located on the top of the heater for
easy accessibility and are protected by a
plastic control flap.
Neon Indicator
The heater has a power available red light.
When the heater has been turned on at
the wall, the light will be illuminated
indicating power is available to the heater.
Heat Controll Switch
Your heater is fitted with a multi-positional
rotary switch.The control switch
positions are:
0 Off
∞ Fan only
I Low heat – 1200W
II High heat – 2400W
Check that the heat control switch is set
to the off position before plugging the
heater into the mains supply.
Fan
The fan setting is used to circulate the
room air.
Turn the thermostat clockwise until the
maximum temperature setting is reached.
The fan will now circulate the room air.
3