Kyocera Milan KX9C - Manual (Page 5)

User Guide for the Kyocera Milan KX9B/KX9C Phones v
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Your service provider’s network controls the power
of the RF signal. This power level can range from
0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure
guidelines with safety levels for hand-held
wireless phones. These guidelines are consistent
with the safety standards previously set by both
U.S. and international standards bodies in the
following reports:
•
ANSI C95.1
(American National Standards Institute, 1992)
• NCRP Report 86
(National Council on Radiation Protection and
Measurements, 1986)
• ICNIRP
(International Commission on Non-Ionizing
Radiation Protection, 1996)
Your phone complies with the standards set by
these reports and the FCC guidelines.
E911 mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates
issued by the FCC.
Battery and charger specifications
093 453 037
Kyocera Wireless Corp.
10300 Campus Point Drive, San Diego, CA 92121
U.S.A.
Visit us at www.kyocera-wireless.com
To purchase accessories, visit
www.kyocera-wireless.com/store
Charger Input Output
CV90-G2926 100-240 VAC / 50 / 60 Hz 4.5 V 1.2 A
CV90-60859-01 120 VAC / 60Hz 5.2 V 400 mA
Standard Battery
CV90-M6310-01, 3.7V / 850mAh
Extended Battery
CV90-M3145-11, 3.7V / 1350mAh