Kenwood Z919 - Manual (Page 18)

— 18 —
English
Direct Alphabet Input (Function of remote)
You can directly input letters using the number/letter entry
buttons on the remote.
Example: Use the following table to enter the name "DANCE".
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 12 characters for each name.
Assigning Names
Press the NAME.S button on the unit or the OK button on the
remote.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
• You can assign names up to 30 FM/AM stations in all.
• Station names remain stored even if the reset button is pressed.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.
• Removing this unit from the battery power supply erases station
names.
NOTE
6
NOTE
5
Button to press # Times pressed Character
#3 1
1 #2
#6 2
#2 3
#3 2
“D”
“A”
“N”
“C”
“E”
NOTE
You can assign names to radio stations with the Station Preset
Memory. Up to 30 stations can be assigned names.
Adjust the frequency to the station whose name you want to
enter.
Press the NAME.S button for at least two seconds.
“NAME SET” is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The
4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
4
or ¢ buttons, respectively, on the remote.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows:
4
3
2
1
Station Name Preset (SNPS)
Tuner features