Krell Industries KAV400xi - Manual (Page 13)

Remote Control Only
See Figure 2 on page 6
Krell KAV– 400xi 9
The KAV– 400xi remote control uses one CR2025 lithium battery,
which is included with the shipment.
To open the battery compartment on the back of the remote
control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler’s or eyeglass screw-
driver to move the small switch toward the center of the
remote, while using your index fingernail or screwdriver to pull
down gently on the slot to the right of the switch. The battery
compartment will slide out.
Do not use a knife or other sharp objects to open the battery compart-
ment; they will scratch the remote control finish.
3. Place the battery, positive side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear
a click.
The remote control is ready for operation.
Replace battery when remote control function becomes intermittent.
Remove battery if the remote control is not used for a long period of time.
Battery leakage can damage the remote control.
The KAV– 400xi remote control accesses complete power amplifier
and preamplifier functions. A description of the functions unique to
the KAV– 400xi follow:
12 Pre Key
Use this key to activate the KAV– 400xi remote to access amplifier
commands.
Note
Notes
Battery
Installation
and
Removal
Remote Control
Only Functions
POWER