KITCHENAID KHMS145KSS - Manual (Page 8)

8
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad touch (short tone)
■ End of Timer countdown (long tone)
Two tones
■ Reminder, repeat each minute after the end-of-cycle tones
■ Function has been entered or ex ited
Three tones
■ Invalid pad touch
Four tones
■ End-of-cycle
All Tones
All of the preceding tones are preset on. All ex cept the end of
Timer countdown can be turned off.
To Turn Off/On:
Touch and hold the number pad [2] for five
seconds until two tones sound. Repeat to turn tones back on.
Valid Pad Touch Tones
The valid pad touch tones are preset on, but can be turned off.
To Turn Off/On:
Touch and hold the number pad [1] for five
seconds or until two tones sound. Repeat to turn tones back on.
Timer
The Timer can be set in minutes and seconds, up to 99 minutes
99 seconds and counts down the set time. The Timer does not
start or stop the microwave oven.
When the Timer is in use, the microwave oven can still operate.
To see the time countdown for five seconds while the microwave
oven is in use, touch TIMER.
To Set:
1. Touch TIMER.
If no action is taken after one minute, the display will return to
the time of day mode.
2. Touch the number pads to set the length of time.
3. Touch START.
If not touched within 5 seconds, “START?” will appear on the
display. If not touched withing 1 minute, the display will return
to the time of day.
When the set time ends, “END” will appear on the display and
1 long tone will sound.
4. Touch TIMER or CANCEL/OFF anytime to cancel the Timer.
If using the Timer during a cooking function, do not touch
CANCEL/OFF to cancel Timer, as the cooking function will
also cancel.
The time can be reset during the countdown by repeating the
above steps.
Child Lock
The Child Lock shuts down the control panel pads to prevent
unintended use of the microwave oven.
When the control is locked, only the VENT FAN, LIGHT, and
START pads, and number pads 1 and 2 will function. If any other
pad is touched, 3 tones will sound and “LOCK” will appear in the
display.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Before locking, make sure the
microwave oven and Timer are off. Touch and hold START for five
seconds until two tones sound and a lock icon appears on the
display. Repeat to unlock and remove the lock picture from
display.
Vent Fan
The vent fan has speeds ranging from 1 (LOW) to 5 (HIGH). The
first time the Vent Fan is turned on after power is supplied to the
microwave oven, it will start at speed level 1. Each time the fan is
turned on, it will start at the speed level that was used last.
To protect the microwave oven, the vent fan will automatically
turn on at the HIGH setting if the temperature from the range or
cooktop below gets too hot. It may stay on for up to one hour to
cool the microwave oven. When this occurs, the VENT FAN pads
will not function.
To Turn Vent Fan On/Off:
1. Touch VENT FAN ON/OFF pad.
2. Touch HIGHER or LOWER pad to increase or decrease the
fan speed.
The display will show “FAN” and a number between 1 and 5
to indicate fan speed. After 2 seconds, the display returns to
previous display.
Cooktop Light
The cooktop light has three options: on, night and off.
To Turn On/Night/Off: Repeatedly touch LIGHT ON/NIGHT/OFF
to cycle through options.
Demo Learning Mode
The demo learning mode is ideal for learning how to use the
microwave oven. When set, functions can be entered without
actually turning on the magnetron. The microwave oven light will
come on, the fan will run and, if on, the turntable will rotate.
Before setting, make sure the microwave oven and Timer are off.
To Turn On/Off: Touch and hold TIMER for five seconds until two
tones sound and “d” appears on the display. Repeat to turn off
and remove “d” from the display.