Knoll US4 - Manual (Page 2)

Wiring: Knoll receive
modules (UDR-Quad
or UR-Quad) are
connected to the
US4-Hub with cat 5
unshielded wires
using all 8
conductors.
Connection is made
with the RJ45 connector (RJ45 plug not supplied). Always use standard
cat 5 wiring practices. Using the correct wire pairs and polarity is VERY
important. Each cat 5 wire run is a home run and wires cannot be
shared with two quad receive modules.
Connection to stereo video source equipment: Connect the four
US4 Hub gold RCA jacks with a good quality gold connector four wire
component RCA jumper cable to the appropriate three component
output and digital audio output jacks on your DVD, dish receiver, D-
VHS, VCR, stereo or other equipment. If there is a switched outlet on
your output equipment, you may want to plug the PS1202 power
supply to the switched outlet.
Make sure a good quality RJ45 8-8 crimper is used to
connect the RJ45 connector to the cat 5 wire. Poor crimping
and mismatched wires are the most frequent cause of
installation problems.
Power requirements: The Knoll US4-Hub comes with a 15 VDC power
supply. Each Quad receive module requires a Knoll PS1202 power
supply.
Note: The quad receive modules can be either
decora in-wall style or enclosure style as desired.
Connecting Quad receive modules on to the Projector, TV or
other components: See documentation shipped with the receive
units.
Multiple Connection(s): If more than six component receivers are
required in a system, multiple US4-HUB’s can be connected together.
To wire together a second, third, etc. US4-HUB, connect the LINK OUT
of the first US4-HUB to the LINK IN of the second US4-HUB using a
short as possible tested cat 5 jumper with RJ45 connectors, using all 8
wires. Connect the LINK OUT of the second US4-HUB to the LINK IN of
the third US4-HUB and so on. In this example the second and third
hubs do not have RCA jacks connected but do have their PS1506 power
supply connected.
IMPORTANT: All of the US4-HUB’s not connected via RCA jacks, but
with a cat 5 wire daisy chained from another US4-HUB need to have
their LINK switch positioned in the OUT position. The US4-HUB with
RCA jacks connected needs to have the LINK switch in the IN position.
UR receive units do not have any alterations.
The Knoll send receive system does not have any user adjustments and
is completely automatic. If need be, please call our tech line for details
at 1 800 566 5579.
CAT 5
DLP-TV
DVD Player
PS1506
Quad Receive
PS1202
IN LINK OUT TO QUAD RECEIVE BALUNS
COMPONENT INPUTS
This product may contain lead that some states have determined are
harmful. Wash you hands after touching this product.
Decora™ is a trademark of Leviton Manufacturing.