Kohler Courage SV600 - Manual (Page 9)

9
Figure 7. Oil Level Dipstick.
5. If the level is low, add oil of the proper type, up to
the “F” mark on the dipstick. (Refer to Oil Type on
page 4.) Always check the level with the dipstick
before adding more oil.
NOTE: To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the “L”
mark or over the “F” mark on the
dipstick.
Oil Sentry™
Some engines are equipped with an optional Oil
Sentry™ oil pressure switch. See Figure 8. If the oil
pressure decreases below an acceptable level, the Oil
Sentry™ will either activate a warning signal or shut
off the engine, depending on the application.
NOTE: Make sure the oil level is checked BEFORE
EACH USE and is maintained up to the “F”
mark on the dipstick. This includes engines
equipped with Oil Sentry™.
Change Oil and Filter
Change the oil and oil filter annually or every 100
hours of operation. Refill with service class SG, SH, SJ
or higher oil as specified in the Viscosity Grades table
(Figure 2) on page 4.
Change the oil and filter while the engine is still warm.
The oil will flow more freely and carry away more
impurities. Make sure the engine is level when filling,
checking, or changing the oil. Always use a genuine
Kohler oil filter. Use chart below to determine part
number to order.
Operating
Range
“F” Mark
2. Remove the oil drain plug and oil fill cap/dipstick.
Be sure to allow ample time for complete drainage.
3. Remove the old filter and wipe off the mounting
pad.
4. Reinstall the drain plug. Make sure it is tightened
to 14 N·m (125 in. lb.) torque.
5. Place the new replacement filter in a shallow pan
with the open end up. Pour new oil of the proper
type, in through the threaded center hole. Stop
pouring when the oil reaches the bottom of the
threads. Allow a minute or two for the oil to be
absorbed by the filter material.
6. Apply a thin film of clean oil to the rubber gasket
on the new filter.
7. Install the replacement oil filter to the mounting
pad. Turn the oil filter until the rubber gasket
contacts the pad, then tighten the filter an
additional 3/4 to 1 turn.
8. Fill the crankcase, with new oil of the proper type,
to the “F” mark on the dipstick. Refer to Oil Type on
page 4. Always check the level with the dipstick
before adding more oil.
9. Reinstall the oil fill cap/dipstick and push firmly
into place.
10. Test run the engine to check for leaks. Stop the
engine, allow a minute for the oil to drain down,
and recheck the level on the dipstick. Add more oil,
as necessary, so the oil level is up to but not over
the “F” mark on the dipstick.
NOTE: To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the “L”
mark or over the “F” mark on the dipstick.
Figure 8. Oil Drain Plug, Oil Filter, and Optional Oil
Sentry™ Switch.
Oil Drain Plug
Oil Filter
Oil Filter Part No.
12 050 01-S
52 050 02-S
Length
2-1/2"
3-3/8"
Change the oil and oil filter as follows (see Figure 8):
1. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil fill cap/
dipstick before removing it.
Oil Sentry ™ (Behind
Blower Housing)