Kobe Range Hoods CH0030SQB (30") - Manual (Page 10)

7
Ductwork Installation
8. Use 8” round steel pipe (follow building codes in your
area) to connect the ducting transition on the hood to
the ductwork above. Use duct tape to make all joints
secure and air tight. Refer to Figure 5.
Wiring to Power Supply
S A F E T Y W A R N I N G
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD
MUST BE PROPERLY GROUNDED. MAKE SURE THIS
IS
DONE BY QUALIFIED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL CODES.
BEFORE CONNECTING WIRES, SWITCH POWER OFF
AT SERVICE PANEL TO PREVENT POWER FROM
BEING SWITCHED ON ACCIDENTALLY.
9. Connect electrical wires.
- Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect wires according to their colors (i.e. black to
black, white to white, and green to green). See
Figure 6.
- Store wires in the wiring box.
Final Assembly
CAUTION : Install heating lamps last.
10. Drop oil tunnel into recess support near rear of hood.
Refer to Figure 7.
11. Install baffle filters and stainless spacer(s). Refer to
Measurements and Diagrams on page 21 for baffle
filter and stainless spacer placement. Angle baffle filter
toward back of hood
. Push baffle filter up until
almost level . Slide forward into recess behind the
front of hood . Lower baffle filter . Slide back until
it fits into resting position . Refer to Figure 8.
12. Repeat for all baffle filters and spacers.
13. Install heating lamps (not included), 120 Volts 175
Watts max. each.
Figure 5
Figure 6
Figure 7