KVH Industries TracVision M3 - Manual (Page 3)

1. Unpack the box and ensure it contains
everything shown on the Contents List. Save
the packaging in case you need to reship the
system.
2. Carefully examine all of the supplied parts to
ensure nothing was damaged in shipment.
3. Gather all of the tools and materials listed
below. You will need these items to complete
the installation.
4. Peel off the extra serial number label (taped to
the antenna) and affix it in the appropriate
box on the red Activation Card.
54-0274-01 Rev. A 2 © 2005 KVH Industries, Inc., All rights reserved.
Inspect Parts and Get Tools
1
Always lift the antenna by the
silver base and never by the
radome or any portion of the
internal antenna assembly.
• #2 Phillips screwdriver
• 7 ⁄
16
" open-end wrench
• 7 ⁄
16
" socket wrench
• 1 ⁄
2
" socket or open-end
wrench
• Electric drill
• 5 ⁄
16
" (8 mm) drill bit
• Silicone sealant or
equivalent
• Hole saw of desired diameter
(for cable access hole, see page 4)
• Adhesive tape
• Light hammer
• Center punch
• Four 1 ⁄
4
" fasteners
(optional for mounting the receiver,
see page 10)
Affix Serial
Number
Antenna
Receiver
Connector
Cover
Radome
Base
051099999