Kompernass KH 1106 - Manual (Page 12)

- 10 -
Metal rack 9
Use the metal stand for grilling.
Place a heat-resistant plate underneath the metal
stand. This will collect any splashes of grease or
food.
Important! The metal stand must only be used
on the glass turntable. Always place the metal
stand in the middle of the turntable. When
removing food after cooking, always use oven
gloves or similar.
Please note that it may become very hot inside the
appliance and take care.
Crispy-Pan 0
Use the Crispy-Pan to give a crispy touch to pizza.
Place the Crispy-Pan onto the metal rack.
Important! After cooking the Crispy-Pan is hot.
Use a kitchen cloth to remove the pan.
Note: Clean the Crispy-Pan with a damp cloth.
Never clean in a dish washer.
The Crispy-Pan is suitable for all conventional ready-
made pizzas with a diameter of 25.5 cm.
Cooking in the microwave oven
If you wish to use the classical basic functions of
the microwave (reheat, boiling, cooking), you must
simply select the microwave power and set the desi-
red cooking time. You can choose between eight
power levels from 100 to 800 watts, with a maxi-
mum cooking time of 95 minutes.
1) Select power
•
Press the button o „Power“ the appropriate
number of times to set the required power level.
• 1x for 800 watt power.
• 2x for 700 watt power.
• 3x for 600 watt power.
• 4x for 500 watt power.
• 5x for 400 watt power.
• 6x for 300 watt power.
• 7x for 200 watt power.
• 8x for 100 watt power.
The power is shown in the LED display (e. g. P 800
at 800 watts power).
2) Setting the cooking time
1.
Turn the dial a to set the cooking time.
The increments for setting the time with the
control knob are as follows:
•
from 0 to 1 min: in 5 second increments
• from 1 to 5 min: in 10 second increments
• from 5 to 10 min: in 30 second increments
• from 10 to 30 min: in 1 minute increments
• from 30 to 95 min: in 5 minute increments
Aborting/stopping an input process
Press button
i „Cancel/Stop“ once, to abort or
stop an input process. The appliance switches back
to standby mode.
3) Start the cooking process
To start the cooking process, please press button
s
„Start/quick start“. In the LED display, the symbols
for microwave operation
and cooking
appear. The count down begins.
Note: If you press button s „Start/quick start“
during operation, the cooking time will be in-
creased by 30 seconds, while the power
level remains unchanged.
IB_KH1106_E23715_GB 14.07.2008 14:03 Uhr Seite 10