Kohler San Raphael Pressure Lite Vitreous China Siphon Jet Toilet K-3394 - Manual (Page 4)

4
113362-2- EA (9532)
Kohler Co., Kohler, WI
Install new 1/4” or 5/16” diameter T-bolts.
Fig. #5
T-Bolts
Closet Flange
INSTALLATION
INSTALL TOILET GASKET
Carefully set the new toilet upside down on padding.
Firmly install the gasket onto the toilet outlet. If using a
gasket with an integral plastic sleeve, position the gasket
with sleeve facing away from the toilet.
If a rag or other plug is in the closet flange, remove the rag
from the closet flange before setting the toilet.
Fig. #6
Toilet Outlet
Gasket
ALIGN AND SET TOILET
Carefully align and lower the toilet over the closet flange
and T-bolts.
CAUTION: Risk of external leakage. Do not lift or
rock the toilet after placement – a new toilet gasket
must be installed if you break the watertight seal.
Apply full body weight to toilet rim to set seal.
Fig. #7
SECURE TOILET
Install the bolt cap bases, washers, and nuts onto the
exposed T-bolts.
CAUTION: Risk of personal injury or product
damage. Overtightening may cause breakage or
chipping of the vitreous china.
Handtighten the nuts, then tighten them an additional
1/2-turn with a wrench. If the T-bolts extend more than
1/4” above the top of the nut, cut off the excess with a
hacksaw, and file the cut edges. Wipe away any residue.
Install the bolt caps.
Fig. #8
Bolt Cap
Nut
Washer
Bolt Cap Base