Introduction / general safety notices, Pneumatic hammer drill pebh 1010, Introduction – Kompernass PEBH 1010 User Manual
Page 4: For your safety, Intended use, Equipment, Scope of delivery, Technical information, General safety notices
Pneumatic Hammer Drill PEBH 1010
L
Introduction
L
For your safety
Please make sure you familiarise yourself
fully with the way the device works be-
fore you use it for the first time and that
you understand how to handle electrical power tools
correctly. Further details can be found in the operating
instructions. Keep these instructions in a safe place.
If you pass the device on to anyone else, please
ensure that you also pass on all the documentation.
L
Intended Use
The PEBH 1010 hammer drill is suitable for:
- hammer drilling in bricks, concrete and
natural stone
- drilling in wood, plastic and metal
- screwing in wood, plastic and metal
- chiselling in concrete, stone and plaster
Any other use of or changes to the device is consid-
ered to be inappropriate and harbours a considerable
danger of accidents.
The manufacturer does not accept liability for damage
or losses occurring as a result of the device being
used for purposes other than those stated above.
Not for commercial use.
L
Equipment
Q
Tool holder (drill chuck)
W
Rubber dust protection cap
E
Locking / unlocking cap
R
ON / OFF switch
T
Locking button
Y
Wheel for speed pre-selection
U
Clockwise / counter-clockwise switch
I
Function selector switch
O
Additional handgrip
P
Metal bit stop
L
Scope of Delivery
1 hammer drill
1 additional handgrip
1
quick-action drill chuck
(13 mm) with adapter (see Fig. A)
3 drills (see Fig. B)
1 flat chisel (see Fig. B)
1 pointed chisel (see Fig. B)
1 tin of lubricating grease
1 carrying case
1 operating instructions
1 „Guarantee and Service“ booklet
L
Technical Information
Rated power
consumption:
1010 W
Rated voltage:
230 V ~ 0 Hz
Idle-running speed:
n
0
0 - 1,100 / min
Impact frequency:
0 - ,800 / min
Impact energy:
2.2 joules
Drill hole diameter:
max. 13 mm for steel
max. 32 mm for wood
max. 26 mm for concrete
max. 82 mm
with compass saw
Protection class:
II /
Weight:
3.4 kg
Information on sound levels and vibration:
A-weighted noise level.
Sound pressure level:
99.6 dB(A)
Sound power level:
112.6 dB(A)
Weighted acceleration, typical:
Hand-arm vibration:
8. m / s
2
Measured values determined in accordance
with EN 0 144.
L
General Safety Notices
J
Attention! When using electric-powered tools
the following fundamental safety instructions
need to be observed for your protection against
Introduction / General Safety Notices
6 GB/IE