Kolcraft S77-T-R3 - Manual (Page 6)

6
To Assemble Front Wheel Tube
1
Place stroller so the handle bar and rear
wheels are touching the floor.
Position front wheel assembly over
plastic side housings.
Align tubes with plastic housings and
push front wheel assembly on the frame.
You may need to depress the spring
loaded buttons slightly while assembling
the tubes.
N NO OT TE E:: If your spring loaded button
becomes out of place, take pliers and
feed button into hole.
N NO OT TE E:: Make sure that spring loaded
buttons pop through.
C CA AU UT TIIO ON N:: If spring loaded buttons DO
NOT pop through, front wheel assembly
could fall off during use.
Secure Front Wheel Tube to the front
frame tubes using screws. The screws
should be aligned into the 2 holes
located on the underside of plastic
side housing. Secure with a Phillips
screwdriver on both sides.
2
3
4
4
2
3
Side Housing