Kompernass KH 150 SE - Manual (Page 12)

10 GB/IE
• Place the food to be sliced on the food
carriage P.
If necessary, press the food to be sliced with
the food holder plate { lightly against the
food support q.
• Switch the appliance on and, whilst lightly
pressing the food to be sliced forward, guide
it along the cutting blade }. After using the
slicer always set the food support plate into
the „0“ setting so that the sharp blade is
covered. The cutting blade } is ideally suit-
able for cutting wafer-thin slices of cold cuts
or boiled ham (see Fig. A).
• To safeguard your fingers always use the food
carriage P and the food holder plate {
(Exception: slicing very large pieces of
foodstuffs).
Cleaning, maintenance and disposal
Cleaning
m Important safety advice for cleaning
the slicer
1. Before starting to clean the slicer; switch it
off, remove the plug from the mains socket
and set the food support plate q into the „0“
setting.
2. Do not submerse the slicer in water.
3.
Risk of serious injury: The cutting blade }
is very sharp!
Accessories suitable for dishwashers!
• Clean the food carriage P, the food holder {
and the catch-tray t in the dishwasher.
• It is necessary to clean the slicer thoroughly
at regular intervals as perishable food scraps
could accumulate on the appliance or behind
the cutting blade }.
• Clean all appliance parts not suitable for the
dishwasher with a lightly moistened cloth.
Wipe off the appliance housing T, the cutting
blade covering Y, the support table with
guide slots O and the food support plate q
carefully. Do not use abrasive cleaning agents,
sponges with rough surfaces or hard brushes.
Cleaning brush:
• Use the bristles of the cleaning brush u to
remove remnants such as crumbs from all
difficult to reach positions. The flattened end
can be excellently used to remove stubborn
soiling.
• Carry out all tasks using the cleaning brush
with great care. Should it slip close to the
cutting blade, there is the risk of receiving a
severe personal injury.
Maintenance / Removing / assembling
the cutting blade
m Important safety notices for the removal
and assembly of the cutting blade!
1. Switch the slicer off, remove the plug from the
power socket and set the food support plate q
into position „0“.
2. Risk of personal injury! The cutting blade
is very sharp! For the removal and assembly
wear appropriate safety gloves. Otherwise,
you could receive cut injuries.
• Open the blade cover Y by pressing the
blade cover unlock button R. Remove the
blade cover Y.
• Remove the plastic screw clip y from the
mounting and screw the blade lock of the cut-
ting blade } out by unscrewing it to the left.
• When taking out the blade } make sure that
you grasp it at its centre.
Operation / Cleaning, maintenance and disposal