KTM 1190 RC8 FR - Manual (Page 184)

MAINTENANCE WORK ON CHASSIS AND ENGINE
182
700338-01
– When you screw in the rear left fixing screw, the plug-in cable binder  is pushed
out of the thread. To reposition the cable of the lambda probe, fix the plug-in cable
binder in the remaining free drill hole.
Info
Check the cable routing. The cable of the lambda probe must not be taut.
700327-12
Setting a lower seat position:
– Remove screw
 with washer on the left and right side of the vehicle.
– Press the rear end down until the drill holes of the frame are level with the upper
rear drill holes of the frame rear.
– Fit the screw and washer on the left and right sides of the vehicle, but do not
tighten.