Dust bag indicator and changing the dust bag, Replacing filters, Motor protection filter – Kambrook KVC20 User Manual

Page 5

Advertising
background image

5

finger inside the thumb groove and pull
the compartment lid upwards.

Turn off the vacuum cleaner when
changing any attachments.

Dust bag indicator and
changing the dust bag

The dust bag should be changed when full.
The dust bag indicator window will
gradually turn red as the bag fills up and
when the dust bag indicator displays ‘red’
it is time to change the dust bag.

Always switch appliance off, then switch off
at the power outlet and unplug the appliance
prior to replacing dust bags or filters.

To remove the dust bag, ensure the unit is
down on its wheels, remove the crush
proof hose and push the ‘Dust bag
compartment lid release lever’ underneath
the handle. Once the lid has released, pull
the top cover back.

To remove the bag, grasp the top of dust bag
and pull out, and dispose in a rubbish bin.

To place a new dust bag, take a fresh dust
bag and with the arrow (printed on the
material section of the dust bag) pointing
down slide the material down into the
dust bag holder, until it comes in contact
with the bottom of the holder.

HINT: once the bag is inserted ‘puff-out’ the bag as
much as possible to ensure the full capacity of the
bag can be taken up.

When vacuuming fine dust particles, the
fine dust particles can clog the pores of
the dust bag and the dust bag indicator
will indicate full. If this happens the bag
could appear relatively empty, however
the bag will still need to be changed to
avoid strain on the motor.

NOTE:The bag compartment lid may not close if
the bag is not correctly fitted.

IMPORTANT: DO NOT USE THE
UNIT WITH OUT A DUST BAG
IN PLACE

Replacing filters

Filters must be cleaned from time to time
to remove the fine dust particles that have
been collected.This can be done by shaking
them; however after approximately 5 dustbag
changes the filters should be replaced.

Motor protection filter

The motor protection filter must always
be in place when operating the vacuum
otherwise damage to the motor may occur

To replace the motor protection filter –
Remove the dustbag or pull the bag
forward.The motor protection filter is
located at the rear, right hand side of this
inner chamber. Pull the plastic filter holder
upward to remove.

Dust bag holder

Filter holder

HEPA filter

Filter holder

Removable filter

Advertising