Kenmore 625.381560 - Manual (Page 17)

17
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
Step 7 - Sanitize, Test and Purge System
Figure 23
PRESSURE TEST THE SYSTEM
NOTE: Complete the sanitizing procedures on the pre-
ceding page before pressure testing.
To pressure test the system, complete the following
steps.
1. Open the water supply valve to the Reverse Osmosis
System. See Figure 23.
2. Open the main water supply valve and several house
faucets. This will purge air from the house plumbing
and system. Close faucets when water runs smooth.
See Figure 23.
3. Pressure will start to build in the RO system in about 2
hours Carefully check all fittings and connections as
the system builds pressure. Check for water leaks. Fix
leaks if any are found. If problems exist, refer to the
troubleshooting chart or call the toll free number.
NOTE: When the system is first pressurized, water
may ''spurt'' from the faucet air gap hole until air is
expelled from the RO system.
Please review the following operating features before
using your Reverse Osmosis System:
You will not have filtered water immediately. It may
take 1-3 hours to completely fill the storage tank and
create maximum flow from the Reverse Osmosis
faucet.
Water Pressure from the Reverse Osmosis faucet will be
less than your standard faucet due to the high level of
filtration performed by the system.
Water will run to the drain while the Reverse Osmosis
system is producing purified water, even if you are
not drawing water from the Reverse Osmosis faucet.
You may hear a small quantity of water going to the
drain for a couple of hours. Water going to the drain
will automatically shut off when the storage tank is
full.
PURGING THE SYSTEM
To purge the system, complete the following steps.
1. Open the Reverse Osmosis Faucet and let water
through the system for a 24 hour period.
NOTE: Water flow will be a slow trickle at this time.
2. Close the Reverse Osmosis faucet after the 24 hour
purging period is complete.
3. When the purging is finished, your Reverse Osmosis
system is ready for use.