Kenwood DNX7360BT - Manual (Page 2)

2 DNX SERIES/ DDX SERIES
Installation Procedure
1
..........1
2
..........1
3
..........1
4
..........1
5
..........2
6
..........1
7
..........1
8
..........6
9
..........6
0
..........1
!
..........1
@
..........1
#
DNX7360BT,
DNX7360BTM only
..........1
$
DNX7360BT,
DNX7360BTM only
..........1
Accessories
1. To prevent a short circuit, remove the key
from the ignition and disconnect the -
battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the speaker wires of the wiring
harness.
4. Connect the wiring harness wires in the
following order: ground, battery, ignition.
5. Connect the wiring harness connector to
the unit.
6. Install the unit in your car.
7. Reconnect the
- battery.
8. Press the reset button.
9. Perform the Initial Setup. (Refer to the
Instruction Manual.)
2WARNING
• If you connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those wires to the
power source running through the fuse box.
• Do not cut out the fuse from the ignition wire
(red) and the battery wire (yellow). The power
supply must be connected to the wires via the
fuse.
Acquiring GPS Signals
The first time you turn on DNX7360BT,
DNX7360BTM, you must wait while the
system acquires satellite signals for the first
time. This process could take up to several
minutes. Make sure your vehicle is outdoors
in an open area away from tall buildings and
trees for fastest acquisition. After the system
acquires satellites for the first time, it will
acquire satellites quickly each time thereafter.
About the Front Panel
When removing the product from the
box or installing it, the front panel may be
positioned at the angle shown in (Fig. 1). This
is due to the characteristics of a mechanism
the product is equipped with.
If the program that is activated when the
$AA/A'PINKUJKPFF