Kenmore 625.38461 - Manual (Page 5)

5
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
Plan Your Installation
Typical Under Sink Installation
Figure 2
7-5/8"
SINK
filtered water
faucet
cold water
supply fitting
cold water shutoff
WATER
IN
tubing
WATER
OUT
mounting
screws (2)
Filter I Filter II
Tools Needed
Adjustable Wrench
Phillips Screwdriver
Drill & 1-1/4” bit, if required
Large Adjustable Jaw Pliers or Pipe Wrench
PLAN YOUR INSTALLATION
It is recommended to read through the entire manual
before beginning your installation. Follow all steps
exactly. Reading this manual will also help you get all
the benefits from your system.
TYPICAL UNDER SINK LOCATION
The Two-Stage Drinking Water Filter housing is normal-
ly located under the kitchen and/or bathroom sink, to fil-
ter the cold drinking water. See Figure 2.
CHECK SPACE REQUIREMENTS
Check size and position of items for proper installation
into location chosen.
TOOLS NEEDED
Review the tools needed list. See Figure 1. Gather need-
ed tools before proceeding with the installation. Read
and follow the instructions provided with any tools list-
ed here.
IMPORTANT: A 1-1/4” dia. hole is needed to mount the
filtered water faucet. To avoid damaging the sink, con-
sult a qualified plumber or installer for drilling proce-
dures in porcelain or stainless steel.
Figure 1
NOTE: Allow a minimum space of 1-1/2” under the
system for removing the sumps (to change cartridges).
NOTE: To change the filter cartridge,
turn off the water and release pressure
by opening the faucet. A nearby shutoff
is convenient. Most sinks already have
shutoff valves on the supply pipes.