Kolcraft S67-T - Manual (Page 7)

7
To Assemble iPod ® Dok
(select models)
1
2
3
4
2
3
4
Determine which iPod ® model you own
(iPod ® mini, 60GB iPod ® , 40GB iPod ® ,
30GB iPod ® or the 20GB iPod ® ). See
www.apple.com for assistance in deter-
mining which model you have.
If you own the iPod ® mini, proceed to
Step 3. For all other models, remove the
iPod ® mini adapter by flexing the snap
tab and pulling up on the adapter.
Release the snap that holds the iPod ®
Dok in the closed or portable position.
Select the proper donut-shaped protec-
tion pad for your iPod ® . For the mini,
30GB or 20GB iPod ® , select the thick
donut-shaped protection pad with
yellow backing paper. For the 60GB or
40GB iPod ® , select the thin donut-shaped
protection pad with white backing paper.
Remove the backing paper from the
foam, and place the adhesive side of the
foam pad onto the back of the speaker
housing.
Insert your iPod ® into the iPod ® Dok or
insert your iPod ® mini into the iPod ®
adapter. Insert the speaker Jack into
your iPod ® device.
For use on a flat surface such as a table
top, rest the iPod ® Dok on the surface in
the open position. For portable use with
your stroller, push the speaker housing
and the iPod ® cradle together until you
hear a snap. DO NOT turn the iPod ®
Dok upside down, unless the Dok is in
the closed or latched position.
Power and volume of the iPod ® Dok are
controlled through your iPod ® device.
Turn on your iPod ® and adjust the vol-
ume of your iPod ® to a desired level.
NOTE: Song volume and clarity will vary
with the quality of the song data that
you downloaded to your iPod ® .
WARNING
DO NOT turn the iPod ® Dok upside
down, unless the Dok is in the closed and
latched position. iPod ® could fall out.
5
6
7
6
5