Kambrook KMT90 - Manual (Page 3)

Operating Instructions
1. Rotate the program dial clockwise until the time
indicator located on the socket face, matches
the current time.
Switching is possible with the long stem of the timer
pin only.The inner circle of holes on the timer are
for switching on, and the outer circle of holes are
for switching off.
2. Place the grey pin with the indicator arrow
pointing “INWARD” where the timer is to turn
on.Then insert the white pin with the arrow
pointing “OUTWARD” where the timer is to
turn off.
3. Plug your timer into a regular 230/240 Volt
household power point and turn power on.
4. Plug the appliance or lamp into the timer and
turn the appliance or lamp on.
5. Be sure the manual override is NOT set on
the (timer) position.
To override the pre-set program and allow power
through the timer, move the red override lever, to
the position, this will turn your appliance on.
Shortly after the timer has executed any program,
the manual override cannot be moved for
approximately 10 minutes.
NOTE: If the power supply to the timer is interrupted, it
is necessary to reset the current time setting.