Kathrein UFX 314 - Manual (Page 9)

9
Ignore this message by clicking “Continue Anyway”.
The driver is now installed.
The driver installation is now complete.
Windows confi rms again that the driver has been
installed.
Note:
After driver installation has been completed, a new network
connection will be available (name “USB Ethernet/RNDIS”)
which can be confi gured and used as a standard (Ethernet)
network connection.
If this message does not appear or if you have selected
“Zeroconf” (factory setting) as the address for UFX 314
network confi guration, you do not have to take any
further steps.
Otherwise, double-click the network symbol in the task
bar or select the respective network connection
(name “USB Ethernet/RNDIS”) in the Control Panel
under “Network connections”.
Important note:
The warning message (network symbol with an exclamation point on the task bar) can be ignored in this case.
This warning only means that Windows has assigned an automatically determined confi guration (“Zeroconf”) to the network
connection, and therefore may be the reason why there is no connection to the Internet or to other network resources. It is,
however, possible to activate the UFX 314 via USB without any restrictions, as long as the the mode “Zeroconf” was selected
for address allocation (factory setting).