Krown Manufacturing Model Krown 100 - Manual (Page 37)

Before you put in a new roll of paper, look at the way the paper is in the machine now. Notice that the
paper comes off the BOTTOM of the roll and up behind the print head.
To load paper:
1. Remove the paper cover by pushing it toward the rear of the
unit and lifting up. See Figure 1. Be sure to remove and save
the paper roll spindle that is inside the paper roll you are
removing; you will need it later.
2. Cut or tear the paper as show in Figure 2 to separate the paper
roll from the paper in the machine.
3. To remove the paper remaining in the printer, press the
RETURN key several times until the paper comes out at the
top of the printer.
4. Cut the paper at the end of the new roll into a point of
“V” shape:
Place the paper roll spindle that you removed in Step 1 into the hole in
the center of the paper roll.
5. Insert the new paper roll by feeding the paper into the well.
Be sure that paper feeds from the BOTTOM of the roll.
See Figure 3.
6. Using the RETURN key, feed the paper until it comes up
behind the print head. Continue feeding until the paper comes
up through the paper cutting window, as shown in Figure 4.
7. Place the roll of paper in the paper well and replace the plastic
cover on the machine.
Please Note:
• The Krown 100 does not use any ink or ribbon. Instead it uses special paper that prints using heat.
This paper is called “thermal printing paper”. Your Krown 100 will not work with any other kind
of paper.
• To insure that you receive the highest quality thermal printing paper, order from your local
Krown distributor..
XIII
34
LOADING AND CHANGING THE PAPER
Figure 4
Figure 1
Figure 2
Figure 3