Kawasaki PVS1112 - Manual (Page 22)

GB - 21
TROUBLESHOOTING GUIDE
SYMPTOM CAUSE (AND REMEDY)
Severe hum or noise is
heard.
The disc does not play.
• The region number of the disc does not match the region number of the unit.
• DVD mode is not selected, select DVD on AV IN/DVD switch.
• Clean the disc.
• The disc is scratched.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
• There is no disc inside ("No Disc" appears on the screen).
• Insert the disc correctly with the playback side facing down on the disc tray.
• Clean the disc.
• A non-Valid disc has been inserted. The unit and disc region number are incompatible.
• Condensation may have formed inside the unit due to a sudden change in temperature.
Wait about an hour for it to clear and try again.
No picture
The picture is not clear
• Make sure that you've select DVD mode.
• The system is in pause mode or in Slow-motion Play mode. Press the PLAY button
to return to normal play mode.
• Fast forward or fast reverse is performed. Press the PLAY button to return to normal
play mode.
• Make sure that AUDIO/VIDEO output and AV IN input connections are correct.
• The DTS DVD disc cannot be decoded for speaker output.
• This unit is too hot, shut off the unit for 30 minutes to cool down.
• Check that the AC adaptor and AC power cord is connected.
• Turn on the unit.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the battery in the remote.
No power.
The remote does not
function.
DVD
No sound or only a very
low-level sound is
heard.