Kambrook CORDFREE KSK110 - Manual (Page 5)


OPERATING INSTRUCTIONS
OPERATING YOUR KAMBROOK
STAINLESS STEEL 1.8L KETTLE
BEFORE FIRST USE
Remove any packaging material and promotional
labels before using your kettle for the first time.
It is recommended that before the first use to fill
the kettle to the maximum level with cold tap
water, bring to the boil and then discard the water.
Your kettle will only operate when positioned on
the power base with the ON/OFF switch in the ON
position. The kettle will automatically switch off
once the water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle with water, remove it from the
power base and open the lid by pressing the
button on the top lid of the kettle and lifting
the lid upwards. Fill with the desired amount of
water. Do not operate the kettle without water.
Always fill the kettle between the minimum and
the maximum marks on the water window. Too
little water will result in the kettle switching off.
Ensure that the lid is closed and locked firmly
into place before placing the kettle on the
power base.
Place the kettle firmly onto the power base. Plug
the power cord into 230/240V power outlet and
switch ‘ON’.
Press the ON/OFF switch to the ‘ON’ position.
The power ‘ON’ light will illuminate.
NOTE: Never operate the kettle dry - too little water
will result in the kettle switching “OFF”.
Do not overfill the kettle - filling above the maximum
mark on the water window may result in boiling
water splashing from the kettle.
NOTE: This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do not
pour the water too quickly.
NOTE: Do not remove the kettle from the power
base during operation. Ensure the kettle has
switched to ‘OFF’ position after the water has
boiled before removing the kettle from the power
base.
1.
2.
3.
4.
The kettle will automatically switch ‘OFF’ once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
The kettle should be stored on its power base when
not in use. The power outlet should be switched
off and the power cord unplugged from the power
outlet when not in use.
 Caution: this applianCe is designed for the boiling
of drinking quality water only, never use it to heat
or boil any other liquids or foodstuffs. the lid
should always be firmly in plaCe and loCked Closed
before use.
 Caution: do not release the lid while the water is
boiling. ensure the lid is Closed whilst boiling.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water. If this occurs
the kettle will stop heating and automatically
switch off.
Should this occur, switch off at the power outlet
and unplug. Allow kettle to cool before refilling.
When the kettle has cooled down, the safety
device can be reset by removing and then replacing
the kettle on its base.
5.
KSK110_KETTLE_IB_FA.indd 5 20/5/09 1:49:05 PM