Kensington MP-20E - Manual (Page 24)

E-24
Still Image Display
Regular Operation
This operation freezes the currently projected image.
Operation with the Projector
Press the FREEZE/CAPTURE button.
Operation with the Remote Control
Press the FREEZE/CAPTURE button.
Cancelling the Still Image Display
Operation with the Projector
Press the FREEZE OFF button.
NOTE:
• The FREEZE LED is lit green during the still image display.
• A press of the FREEZE/CAPTURE button while a moving image is projected will result in a still image display at the
existing zoom magnification and position.
• A press of the FREEZE/CAPTURE button at the time of still image of OHP will result in a return of the zoom magnification
and position to the original condition.
• A press of the projector INPUT SELECT buttons or one of the remote control OHP / PC / VIDEO buttons during a still
image display will cancel the still image of the PC or video deck. OHP will retain the still image.
Adjusting the Brightness
NOTE: Once the brightness adjustment bar has been displayed, it will disappear after 10 seconds if there is no brightness
adjustment.
Brightness adjustment bar
Operation with the Projector
Adjust using the BRIGHTNESS ( ) buttons.
: Projection image becomes brighter
: Projection image becomes darker
Operation with the Remote Control
Adjust using the BRIGHTNESS (+)/(-) buttons.
(+) : Projection image becomes brighter
(–) : Projection image becomes darker
To change the brightness, perform a manual adjustment using the method described below.
NOTE: The FREEZE LED will go off when the still image display is cancelled.
Operation with the Remote Control
Press the FREEZE OFF button.