Kalorik USK CCG 2 - Manual (Page 6)

6 USK CCG 2 - 071214
HOW TO MAKE COFFEE?
• Make sure the jug is placed correctly on the hotplate.
• Open the lid of the water tank (the smallest lid on top of the
appliance) and fill the water tank with cold water. The number of
cups can be read on the graduated water tank. Close the lid.
• Pull the filter holder out using its handle, fill the permanent filter
with the desired quantity of ground coffee or use the grinder (see
“USING THE COFFEE GRINDER” section). Then replace the filter
holder in its initial position.
• To switch on your appliance, press once the 0/1 switch at the
back of the appliance.
• When you remove the jug from the appliance, a non-drip valve
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the jug automatically opens
the non-drip valve and allows remaining coffee to filter trough
into the jug.
• Once the water tank is empty, we advise you to wait until the
brewing process is finished and the filter has run empty before
removing the jug.
• You can switch off your appliance anytime simply by pressing the
ON/OFF switch until all pilot lights are off.
• The warming plate will start automatically with the appliance.
You can also start this function separately. Place the jug on the
warming plate and then press the warming plate button.
USING THE COFFEE GRINDER
• Install the fineness knob on the machine. The knob has been
adjusted correctly to get the ideal result.
• Make sure the coffee beans are dry and without any impurity.
• Open the lid from the coffee grinder and put the upper part of
the coffee grinder on the lower part.
• Fill it with the desired amount of coffee beans.
• If you want to grind coffee to prepare only 1 to 4 cups of coffee,
press the “4” button. It will reduce the time of grinding coffee to
20 seconds instead of 30 seconds for 5 or 6 to 10 cups (default
setting).